8/9/2023 0 Comments Fldigi rig control filesIcom 7610 Rig Control N3FJP Amateur Contact Log and Fldigi. So, if you’d like to try Fldgi the easy way with the Icom 7610, have a look. I've found a little bug: on startup Log4OM don't remeber the CAT configuration and I have to put again the Hamlib FLRig config (prevoiuos Log4OM step 2). So far I have not seen an Icom 7610 Fldigi RigCAT file. This configuration works fine also with this configuration for WSJT-Xġ) In configuration window on Radio tab select "FLRig FLRig" in Rig dropdown field and the selcet FLRIG address:port in the CAT Control->LAN Server field: for me was localhost:7820 to do so you can do this simple setup:Ĥ) Configure->Software Configuration->Auto Start - select the flrig.exe patch in "File Name" field, on field "Plan" select OnProfileOpen and then click on (plus) icon on right low side of the window. ![]() This configuration need FLRIG start before Log4OM. Clicking on the mark tone in the SmartSDR panadapter will center the RTTY. ![]() RTTY is spot on if you set the RTTY sweet spot to 2210 in the Configure->Misc->Sweet Spot Tab of Fldigi. Main screen (RTTY), SmartSDR set to RTTY, 400Hz bandwidth. ALIGN!!ģ) Configure->Software Integration->Applications->FLDigi - check Start Service ON, click on ADIF and now set a new ADIF MONITOR pointing to the FLDIGI LOG ADIF FILE (see before) and check "Upload QSO to external service" if you send to external logs (eQSL, LOTW, etc.) any QSO you write in the log in real time, check "Delete ADFI file after load" to avoid duplications in Log4OM. Main screen (PSK63), SmartSDR set to DIGU, 5.0K slice bandwidth. I'm arrived at Log4om last month and I'm still trying this successfull setup:Ģ) I've turned on server feature on port 7820ġ) Configure->Modem->CW->CAT Keying - mark Yaesu ONĢ) Configure->Rig Control->flrig - mark ON Enable flrig.ģ) check your log.adi file (usual in C:\Users\\fldigi.files\logs\.adiġ) Configure->Hardware Configuration->CAT interface - on Settings tab set on HamlibĢ) Configure->Hardware Configuration->CAT interface - on Hamlib tab set HAMLIB PARAMETERS pointing to "FLRig FLRig Stable", select "Network Connected Radio" and set correct port on TCP Radio parameters (for me 7820) and the. The biggest issue is that not all digital mode apps support all of the rig control packages, so you’ll need to pick up your priorities and sometimes switch around.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |